Study of the effect of synthesized high voltage electric charge of a powder mixture on the physical and mechanical properties of epoxy composites for the transport industry
Keywords:destructive bending stresses, elastic modulus, epoxy composite, impact strength.
For the formation of composite materials and protective coatings for the transport industry, ED-20 epoxy yanoic oligomer, the polyethylene polyamine PEPA and microfine fractions of high-voltage synthesized powder charge were used. The dependence of the content of microdispersed powder on the adhesive, physical and mechanical properties, and residual stresses of epoxy composites has been investigated. It has been proved that for the formation of a composite material or protective coating with improved adhesive and cohesive properties, the optimal particle content is 0.05–0.50 parts by weight per 100 parts by weight of the ED-20 epoxy oligomer. Such materials are characterized by increased mechanical strength and the ability to resist static and dynamic loads, since their properties are significantly increased compared with the matrix. The obtained results of experimental studies of physical and mechanical properties of composite materials are consistent with the test results of samples with adhesive characteristics, indicating their reliability.
Buketov, AV, Zinchenko, DO & Smetankin, SO 2017, ‘Nanomodified dispersed particles and synthetic fibers-filled epoxy composite materials for the metal-polymer tribosystems of transport vehicles’, Nanomechanics Science and Technology: an International Journal, vol. 8, pp. 41–54.
Buketov, A, Maruschak, P, Sapronov, O, Zinchenko, D, Yatsyuk, V & Panin, S 2016, ‘Enhancing performance characteristics of equipment of sea and river transport by using epoxy composites’, Transport, vol. 31(3), pp. 333–342.
Syzonenko, O, Baglyuk, G & Torpakov, A 2012,
‘Variation in the particle size of Fe–Ti–B4C powders induced by high-voltage electrical discharge’, Powder Metallurgy and Metal Ceramics, vol. 51, iss. 3, pp. 129–136.
Syzonenko, O, Sheregii, E, Prokhorenko, S and others 2017, ‘Method of preparation of blend for aluminium matrix’, Composites by high voltage electric discharge. Machines. Technologies. Materials, vol. 11, iss. 4, pp. 171– 173.
Syzonenko, ON, Tregub, VA & Taftai, IeI 2014, ‘Modeling and analysis of electric discharge processes in a Ti powder layer in kerosene’, Bulletin of the Ukrainian Material Science Society, iss. 7, pp. 55–61. (in Ukrainian)
How to Cite